QUICK START GUIDE CONTINUED
7. Remove Opal Side Tank’s clear reservoir from
its base.
8. Unscrew Opal Side Tank’s cap from the reservoir.
Fill the clear reservoir with water.
9. Replace Opal Side Tank’s cap. Ensure the cap is
clean when installing.
10. Carefully flip over Opal Side Tank’s reservoir and
place in the base. Water should start flowing into
the Opal Nugget Ice Maker and bubbles in the Opal
Side Tank will appear periodically during the time
water is flowing to the ice maker.
NOTE: If water does not appear to flow into the ice
maker, please check for the following:
- There may be bubbles in drain tube (B) connecting
the Side Tank to the Opal.
- Tube (B) is not lying flat.
If either of the above issues are present, adjust tube (B)
to allow the water to flow.
11. Fill Opal Nugget Ice Maker’s reservoir.
12. Plug in Opal Nugget Ice Maker, and begin making ice.
QUICK START GUIDE
Unplug this drain tube (B)
from the black hanger and
connect this tube to the
Side Tank.
3
To Next Page
Loading...