3Com 3CRDSF9PWR-US - OfficeConnect Managed Fast Ethernet PoE Switch - Defining IP Addressing

142 CHAPTER 9: CONFIGURING IP AND MAC ADDRESS INFORMATION
Defining IP
Addressing
The IP Setup Page contains fields for assigning an IP address. The Default
Gateway is erased when the IP Address is modified and changed. Packets
are forwarded to the default gateway when sent to a remote network.
Monitor user has no access to this page.
To define an IP interface:
1 Click Administration > IP Setup. The IP Setup Page opens:
Figure 74 IP Setup Page
The IP Setup Page contains the following fields:
■ Configuration Method — Defines whether the IP address is
configured statically or dynamically. The possible field values are:
■ Manual — Specifies that the IP Interface is configured by the user.
■ DHCP — Specifies that the IP Interface is dynamically created.
■ IP Address — Defines the IP address.
■ Subnet Mask — Defines the subnet mask.
■ Default Gateway — Defines the default gateway.
2 Select Manual or DHCP mode.
3 If Manual is selected, configure the IP Address, Subnet Mask and Default
Gateway.
4 Click . The IP configuration is enabled, and the device is
updated.