178 CHAPTER 13: CONFIGURING QUALITY OF SERVICE
2 Define the trust mode.
3 Click . The selected Trust mode is enabled on the device.
Viewing Bandwidth
Settings
The Bandwidth Summary Page displays bandwidth settings for each
interface.
To view Bandwidth Settings:
1 Click Device > QoS > Bandwidth > Summary. The Bandwidth
Summary Page opens:
Figure 95 Bandwidth Summary Page
The Bandwidth Summary Page contains the following fields:
■ Interface — Displays the interface for which rate limit and shaping
parameters are defined.
Ingress Rate Limit
■ Status — Indicates the ingress rate limiting status on the interface.
The possible field values are:
■ Enabled — Ingress rate limiting is enabled on the interface.
■ No Limit — Ingress rate limiting is disabled on the interface. This is
the default.
■ Rate Limit — Indicates the ingress traffic limit for the interface. The
field options include 128, 1024, 5056, 10048, 50048, 100032 and
500032 kbits per second.
To Next Page
Loading...
