207
Configuring Logging The Logging Setup Page contains fields for defining which events are
recorded to which logs. It contains fields for enabling local logging or
sending logs to Syslog servers.
Monitor users have no access to this feature.
To define Log Parameters:
1 Click Administration > Logging > Setup. The Logging Setup Page
opens:
Figure 109 Logging Setup Page
The Logging Setup Page contains the following fields:
■ Enable Local Logging — Specifies if device logging to local Cache
and Flash memory is enabled. Local logging is enabled by default.
■ Severity level — Specifies the minimum severity level for which a
message will be logged. When a severity level is selected, all severity
level choices above the selection are selected automatically. The
possible field values are:
■ Emergency — The highest warning level. If the device is down or
not functioning properly, an emergency log message is saved to
the specified logging location.
■ Alert — The second highest warning level. An alert log is saved, if
there is a serious device malfunction; for example, all device
features are down.
To Next Page
Loading...
