Diagnosing Problems 63
A
TROUBLESHOOTING
Diagnosing Problems
If you have difficulty with the Access point, try the following
solutions.
Symptom
After you change the IP address, restore a backup configuration,
or reset the Access Point to factory defaults, the Configuration
Management System stops responding and you cannot continue
configuring the Access point. If you change the IP address and
click Apply, you cannot continue to configure the device using
the old IP address. Similarly, after you restore a backup
configuration or reset the Access Point to factory defaults, the IP
address setting may be changed.
Solution
To recover from this situation and continue configuring the
Access Point:
1 Close your browser.
To Next Page
Loading...