66 Diagnosing Problems
should also obtain its IP settings from the DHCP server, make sure
this is configured properly on the IP Network page and applied
just before ending the session.
Symptom
Disconnecting the Access Point
Solution
To disconnect the Access Point:
CAUTION: Disconnecting the Access Point ends the network
association. To avoid possible data loss, exit all networking
applications on connected devices before you disconnect the
Access Point.
1 Unplug the Access point Ethernet cable from the hub or other
device.
2 Unplug the Access point power cord.
Symptom
Uninstalling Software and Documentation
Solution
If you want to uninstall the 3Com 11a/b/g/n Wireless Workgroup
Access point software and documentation, you can either use the
standard operating system procedure for removing programs or
use the following shortcut:
To Next Page
Loading...