112 CHAPTER 6: IP SERVICES COMMANDS
■ ip-addr/mask-length — IP address and subnet mask length in CIDR
format (for example, 10.10.10.10/24).
■ gateway — IP address, DNS hostname, or alias of the next-hop router.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command removes the route to destination
10.10.10.68/24 through gateway router 10.10.10.1:
WX1200# clear ip route 10.10.10.68/24 10.10.10.1
success: change accepted.
See Also
■ “display ip route” on page 123
■ “set ip route” on page 140
clear ip telnet Resets the Telnet server’s TCP port number to its default value. A WX
switch listens for Telnet management traffic on the Telnet server port.
Syntax —
clear ip telnet
Defaults — The default Telnet port number is 23.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command resets the TCP port number for
Telnet management traffic to its default:
WX4400# clear ip telnet
success: change accepted.
See Also
■ “display ip https” on page 121
■ “display ip telnet” on page 125
■ “set ip https server” on page 139
To Next Page
Loading...
