3Com 3CRWX120695A - Install the Equipment; What’s Next?

142 CHAPTER 6: IP SERVICES COMMANDS
The following command adds an explicit route from a WX switch to any
host on the 192.168.4.x subnet through the local router 10.5.4.2, and
gives the route a cost of 1:
WX4400# set ip route 192.168.4.0 255.255.255.0 10.5.4.2 1
success: change accepted.
The following command adds another explicit route, using CIDR notation
to specify the subnet mask:
WX4400# set ip route 192.168.5.0/24 10.5.5.2 1
success: change accepted.
See Also
■ “clear ip route” on page 111
■ “display interface” on page 118
■ “display ip route” on page 123
set ip snmp server Enables or disables the SNMP service on the wireless LAN switch.
Syntax — set ip snmp server {enable | disable}
enable
— Enables the SNMP service.
disable — Disables the SNMP service.
Defaults — The SNMP service is disabled by default.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command enables the SNMP server on a WX
switch:
WX4400# set ip snmp server enable
success: change accepted.
See Also —
■ “clear snmp trap receiver” on page 114
■ “display snmp configuration” on page 127
■ “set port trap” on page 81
■ “set snmp community” on page 149