3Com 3CRWX120695A - Perform Basic Administrative Tasks; Configuring WX Management Services

146 CHAPTER 6: IP SERVICES COMMANDS
set ip telnet Changes the TCP port number on which a wireless LAN switch listens for
Telnet management traffic.
CAUTION: f you change the Telnet port number from a Telnet session,
MSS immediately ends the session. To open a new management session,
you must Telnet to the WX switch with the new Telnet port number.
Syntax —
set ip telnet port-num
■ port-num — TCP port number.
Default — The default Telnet port number is 23.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command changes the Telnet port number
on a WX switch to 5000:
WX4400# set ip telnet 5000
success: change accepted.
See Also
■ “clear ip telnet” on page 112
■ “display ip https” on page 121
■ “display ip telnet” on page 125
■ “set ip https server” on page 139
■ “set ip telnet server” on page 146
set ip telnet server Enables the Telnet server on a wireless LAN switch.
CAUTION: If you disable the Telnet server, Telnet access to the WX switch
is also disabled.
Syntax —
set ip telnet server {enable | disable}
■ enable — Enables the Telnet server.
■ disable — Disables the Telnet server.
Default — The Telnet server is disabled by default.