218 CHAPTER 7: AAA COMMANDS
See Also
■ “clear user” on page 176
■ “display aaa” on page 180
set user attr Configures an authorization attribute in the local database on the WX
switch for a user with a password.
(To assign authorization attributes in RADIUS, see the documentation for
your RADIUS server.)
Syntax —
set user username attr attribute-name value
■ username — Username of a user with a password.
■ attribute-name value — Name and value of an attribute you are
using to authorize the user for a particular service or session
characteristic. For a list of authorization attributes and values that you
can assign to network users, see Table 40 on page 209.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — To change the value of an attribute, enter set user attr with
the new value. To delete an attribute, use clear user attr.
Examples — The following command assigns user Tamara to VLAN
orange:
WX4400# set user Tamara attr vlan-name orange
success: change accepted.
The following command assigns Tamara to the Mobility Profile tulip.
WX4400# set user Tamara attr mobility-profile tulip
success: change accepted.
See Also
■ “clear user attr” on page 177
■ “display aaa” on page 180
To Next Page
Loading...
