clear radio-profile 233
■ Removes the radio from its radio profile and places the radio in the
default radio profile.
This command does not affect the PoE setting.
Examples — The following command disables and resets radio 2 on the
MAP access point connected to port 3:
WX1200# clear ap 3 radio 2
See Also
■ “set {ap | dap} radio mode” on page 271
■ “set {ap | dap} radio radio-profile” on page 272
■ “set port type ap” on page 82
clear radio-profile Removes a radio profile or resets one of the profile’s parameters to its
default value.
Syntax —
clear radio-profile name [parameter]
■ name — Radio profile name.
■ parameter — Radio profile parameter:
■ beacon-interval
■ dtim-interval
■ frag-threshold
■ long-retry
■ max-rx-lifetime
■ max-tx-lifetime
■ preamble-length
■ rts-threshold
■ service-profile
■ short-retry
(For information about these parameters, see the set radio-profile
commands that use them.)
Defaults — If you reset an individual parameter, the parameter is
returned to the default value listed in Table 57 on page 287.
Access — Enabled.
To Next Page
Loading...
