3Com 3CRWX120695A - Page 244

244 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
Examples — The following command displays the status of a Distributed
MAP:
WX4400# display dap status 1
Dap: 1, IP-addr: 10.2.34.56 (vlan 'default'), MAP model: AP2750,
manufacturer: 3Com, name: DAP1
====================================================
State: operational
CPU info: IBM:PPC speed=266666664 Hz version=405GPr
id=0x28f10158a47f0408 ram=33554432
s/n=0332600444 hw_rev=A3
Uptime: 21 hours, 27 minutes, 51 seconds
Radio 1 type: 802.11a, state: configure succeed [Enabled]
operational channel: 48 operational power: 11
base mac: 00:0b:0e:00:11:96
bssid1: 00:0b:0e:00:11:94, ssid: private
The following command displays the status of a directly connected MAP:
WX1200# display ap status 1
Port: 1, AP model: AP2750, manufacturer 3Com, name: MAP01
====================================================
State: operational
CPU info: IBM:PPC speed=266666664 Hz version=405GPr
id=0x28b08a1e047f1d0f ram=33554432
s/n=0333000288 hw_rev=A3
Uptime: 3 hours, 44 minutes, 28 seconds
Radio 1 type: 802.11g, state: configure succeed [Enabled] (802.11b protect)
operational channel: 1 operational power: 15
base mac: 00:0b:0e:00:d1:02
bssid1: 00:0b:0e:00:d1:00, ssid: public
bssid2: 00:0b:0e:00:d1:02, ssid: employee-net
bssid3: 00:0b:0e:00:d1:04, ssid: mycorp-tkip
Table 49 describes the fields in this display.