3Com 3CRWX120695A - Display Radio-Profile

254 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
See Also
■ “display dap connection” on page 250
■ “display dap global” on page 251
display
radio-profile
Displays radio profile information.
Syntax —
display radio-profile {name | ?}
■ name — Displays information about the named radio profile.
■ ? — Displays a list of radio profiles.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — MSS contains a default radio profile. 3Com recommends that
you do not change this profile but instead keep the profile for reference.
Examples — The following command shows radio profile information
for the default radio profile:
WX4400# display radio-profile default
Beacon Interval: 100 DTIM Interval: 1
Max Tx Lifetime: 2000 Max Rx Lifetime: 2000
RTS Threshold: 2346 Frag Threshold: 2346
Table 54 Output for display dap unconfigured
Field Description
Serial Id Serial ID of the Distributed MAP.
Model MAP model number.
IP Address IP address of the MAP. This is the address that the MAP
receives from a DHCP server. The MAP uses this address to
send a Find WX message to request configuration
information from WX switches. However, the MAP cannot
use the address to establish a connection unless the MAP
first receives a configuration from an WX switch.
Port Port number on which this WX switch received the MAP’s
Find WX message.
VLAN VLAN on which this WX switch received the MAP’s Find
WX message.