3Com 3CRWX120695A - Set {Ap | Dap} Radio Min-Client-Rate

270 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
See Also
■ “display {ap | dap} config” on page 234
■ “set {ap | dap} radio tx-power” on page 273
set {ap | dap} radio
min-client-rate
Sets the minimum rate at which a radio is allowed to transmit traffic to
clients. The radio automatically increases its transmit power when
necessary to maintain at least the minimum rate with an associated client.
Syntax —
set {ap port-list | dap dap-num } radio {1 | 2}
auto-tune min-client-rate rate
■ ap port-list — List of ports connected to the MAP access points on
which to set the channel.
■ dap dap-num — Number of a Distributed MAP on which to set the
channel.
■ radio 1 — Radio 1 of the MAP.
■ radio 2 — Radio 2 of the MAP. (This option does not apply to
single-radio models.)
■ rate — Minimum data rate, in megabits per second (Mbps). The valid
values depend on the radio type:
■ For 802.11g radios—54, 48, 36, 24, 18, 12, 11, 9, 6, 5.5, 2, or 1
■ For 802.11b radios—11, 5.5, 2, or 1
■ For 802.11a radios—54, 48, 36, 24, 18, 12, 9, or 6
Defaults — The default minimum data transmit rate depends on the
radio type:
■ The default minimum data rate for 802.11b/g and 802.11b radios is
5.5 Mbps.
■ The default minimum data rate for 802.11a radios is 24 Mbps.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — If the data rate for traffic sent by a radio to an associated client
falls below the default minimum rate, the radio increases power, in
1 dBm increments, until all clients are at or above the minimum rate.