276 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
■ disable — Configures radios to allow associations with 802.11g
clients and 802.11b clients.
Defaults — The default setting is disable. 3Com 802.11b/g radios allow
associations with 802.11g and 802.11b clients by default.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — You must disable all radios that are using a radio profile before
you can change parameters in the profile. Use the set radio-profile
mode command
.
Even when association of 802.11b clients is disabled, if an 802.11b/g
radio detects a beacon from an 802.11b network, the radio enters
protection mode to guard against interference.
The set radio-profile 11g-only command does not affect the radio
support configured with the set port type ap command. For example, if
you configure a radio to be 802.11b only when you set the port type, the
set radio-profile 11g-only enable command does not enable 802.11g
support on the radio.
Examples — The following command configures the 802.11b/g radios in
radio profile rp1 to allow associations from 802.11g clients only:
WX4400# set radio-profile rp1 11g-only enable
success: change accepted.
See Also
■ “display {ap | dap} config” on page 234
■ “display radio-profile” on page 254
■ “set port type ap” on page 82
■ “set radio-profile mode” on page 287
set radio-profile
auto-tune
channel-config
Disables or reenables dynamic channel tuning (RF Auto-Tuning) for the
MAP radios in a radio profile.
To Next Page
Loading...
