set radio-profile auto-tune channel-holddown 277
Syntax — set radio-profile name auto-tune channel-config
{enable | disable}
■ name — Radio profile name.
■ enable — Configures radios to dynamically select their channels when
the radios are started.
■ disable — Configures radios to use their statically assigned channels,
or the default channels if unassigned, when the radios are started.
Defaults — Dynamic channel assignment is enabled by default.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — If you disable RF Auto-Tuning for channels, MSS does not
dynamically set the channels when radios are first enabled and also does
not tune the channels during operation.
If RF Auto-Tuning for channels is enabled, MSS does not allow you to
manually change channels.
Examples — The following command disables dynamic channel tuning
for radios in the rp2 radio profile:
WX4400# set radio-profile rp2 auto-tune channel-config
disable
success: change accepted.
See Also
■ “set radio-profile auto-tune channel-holddown” on page 277
■ “set radio-profile auto-tune channel-interval” on page 278
■ “set radio-profile auto-tune power-config” on page 280
set radio-profile
auto-tune
channel-holddown
Sets the minimum number of seconds a radio in a radio profile must
remain at its current channel assignment before RF Auto-Tuning can
change the channel. The channel holddown provides additional stability
to the network by preventing the radio from changing channels too
rapidly in response to spurious RF anomalies such as short-duration
channel interference.
To Next Page
Loading...
