280 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
History — Introduced in MSS Version 3.0.
A radio can increase power again if required to preserve the minimum
data rate for an associated client.
Examples — The following command changes the power-backoff
interval for radios in radio profile rp2 to 15 seconds:
WX4400# set radio-profile rp2 auto-tune
power-backoff-timer 15
success: change accepted.
See Also
■ “set {ap | dap} radio auto-tune max-power” on page 266
■ “set {ap | dap} radio auto-tune max- retransmissions” on page 267
■ “set radio-profile auto-tune power-config” on page 280
■ “set radio-profile auto-tune power-interval” on page 281
set radio-profile
auto-tune
power-config
Enables or disables dynamic power tuning (RF Auto-Tuning) for the MAP
radios in a radio profile.
Syntax —
set radio-profile name auto-tune power-config
{enable | disable}
■ name — Radio profile name.
■ enable — Configures radios to dynamically set their power levels
when the MAPs are started.
■ disable — Configures radios to use their statically assigned power
levels, or the default power levels if unassigned, when the radios are
started.
Defaults — Dynamic power assignment is disabled by default.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — When RF Auto-Tuning for power is disabled, MSS does not
dynamically set the power levels when radios are first enabled and also
does not tune power during operation with associated clients.
To Next Page
Loading...
