3Com 3CRWX120695A - Set Service-Profile Auth-Psk

To Next Page

To Previous Page

298 CHAPTER 9: MANAGED ACCESS POINT COMMANDS

See Also

■ “display service-profile” on page 257

■ “set web-aaa” on page 220

■ “set service-profile web-aaa-form” on page 308

set service-profile

auth-psk

Enables preshared key (PSK) authentication of Wi-Fi Protected Access

(WPA) clients by MAP radios in a radio profile, when the WPA information

element (IE) is enabled in the service profile.

Syntax —

set service-profile name auth-psk {enable | disable}

■ name — Service profile name.

■ enable — Enables PSK authentication of WPA clients.

■ disable — Disables PSK authentication of WPA clients.

Defaults — When the WPA IE is enabled, PSK authentication of WPA

clients is enabled by default. If the WPA IE is disabled, the auth-psk

setting has no effect.

Access — Enabled.

History — Introduced in MSS Version 3.0.

Usage — This command affects authentication of WPA clients only.

To use PSK authentication, you also must configure a passphrase or key.

In addition, you must enable the WPA IE.

Examples — The following command enables PSK authentication for

service profile wpa_clients:

WX4400# set service-profile wpa_clients auth-psk enable

success: change accepted.

Other manuals for 3Com 3CRWX120695A