set service-profile cipher-wep104 301
Examples — The following command disables TKIP encryption in service
profile sp2:
WX4400# set service-profile sp2 cipher-tkip disable
success: change accepted.
See Also
■ “set service-profile cipher-ccmp” on page 299
■ “set service-profile cipher-wep104” on page 301
■ “set service-profile cipher-wep40” on page 302
■ “set service-profile tkip-mc-time” on page 308
■ “set service-profile wpa-ie” on page 312
set service-profile
cipher-wep104
Enables dynamic Wired Equivalent Privacy (WEP) with 104-bit keys, in a
service profile.
Syntax —
set service-profile name cipher-wep104 {enable |
disable}
■ name — Service profile name.
■ enable — Enables 104-bit WEP encryption for WPA clients.
■ disable — Disables 104-bit WEP encryption for WPA clients.
Defaults — 104-bit WEP encryption is disabled by default.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — To use 104-bit WEP with WPA clients, you must also enable the
WPA IE.
When 104-bit WEP in WPA is enabled in the service profile, radios
managed by a radio profile that is mapped to the service profile can also
support non-WPA clients that use dynamic WEP.
To support WPA clients that use 40-bit dynamic WEP, you must enable
WEP with 40-bit keys. Use the set service-profile cipher-wep40
command.
To Next Page
Loading...
