324 CHAPTER 10: STP COMMANDS
display spantree
portfast
Displays STP uplink fast convergence information for all network ports or
for one or more network ports.
Syntax —
display spantree portfast [port-list]
■ port-list — List of ports. If you do not specify any ports, MSS
displays uplink fast convergence information for all ports.
Defaults — None.
Access — All.
History — Introduced in MSS Version 3.0.
Examples — The following command shows uplink fast convergence
information for all ports:
WX1200# display spantree portfast
Port Vlan Portfast
------------------------- ---- ----------
1 1 disable
2 1 disable
3 1 disable
4 1 enable
5 1 disable
6 1 disable
7 1 disable
8 1 disable
Table 61 describes the fields in this display.
See Also
■ “set spantree portfast” on page 337
Table 61 Output for display spantree portfast
Field Description
Port Port number.
VLAN VLAN number.
Portfast State of the uplink fast convergence feature:
■ Enable
■ Disable
To Next Page
Loading...
