374 CHAPTER 12: SECURITY ACL COMMANDS
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command displays the port to which security
ACL acl_111 is mapped:
WX4400# display security acl map acl_111
ACL acl_111 is mapped to:
Port 4 in
See Also
■ “clear security acl map” on page 367
■ “display security acl map” on page 373
■ “set security acl map” on page 385
display security acl
resource-usage
Displays statistics about the resources used by security ACL filtering on
the WX switch.
Syntax —
display security acl resource-usage
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — Use this command with the help of 3Com to diagnose an ACL
resource problem. (To obtain 3Com Technical Support, see “Obtaining
Support for your Product” on page 517.)
To Next Page
Loading...
