crypto certificate 391
3 When MSS prompts you for the PEM-formatted certificate, paste the
PKCS #7 object file onto the command line.
Examples — The following command adds the certificate authority’s
certificate to WX certificate and key storage:
WX4400# crypto ca-certificate admin
Enter PEM-encoded certificate
-----BEGIN CERTIFICATE-----
MIIDwDCCA2qgAwIBAgIQL2jvuu4PO5FAQCyewU3ojANBgkqhkiG9wOBAQUFADCB
mzerMClaweVQQTTooewi\wpoer0QWNFNkj90044mbdrl1277SWQ8G7DiwYUtrqoQplKJvxz
.....
Lm8wmVYxP56M;CUAm908C2foYgOY40=
-----END CERTIFICATE-----
See Also
■ “display crypto ca-certificate” on page 400
crypto certificate Installs one of the WX switch’s PKCS #7 certificates into the certificate
and key storage area on the WX switch. The certificate, which is issued
and signed by a certificate authority, authenticates the WX switch either
to 3WXM or Web Manager, or to 802.1X supplicants (clients).
Syntax —
crypto certificate {admin | eap | webaaa }
PEM-formatted certificate
■ admin — Stores the certificate authority’s administrative certificate,
which authenticates the WX switch to 3WXM or Web Manager.
■ eap — Stores the certificate authority’s Extensible Authentication
Protocol (EAP) certificate, which authenticates the WX switch to
802.1X supplicants (clients).
■ webaaa — Stores the certificate authority’s Web AAA certificate, which
authenticates the WX to clients who use Web AAA.
■ PEM-formatted certificate — ASCII text representation of the
PKCS #7 certificate, consisting of up to 4096 characters, that you
have obtained from the certificate authority.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
To Next Page
Loading...
