set server group 411
timeout interval of 30 seconds, two transmit attempts, 5 minutes of dead
time, and a key string of keys4u, type the following command:
WX1200# set radius server RS42 address 198.162.1.1 timeout 30
retransmit 2 deadtime 5 key keys4U
See Also
■ “display aaa” on page 180
■ “set authentication admin” on page 189
■ “set authentication console” on page 191
■ “set authentication dot1x” on page 193
■ “set authentication last-resort” on page 197
■ “set authentication mac” on page 199
■ “set authentication web” on page 201
■ “set radius” on page 407
■ “set server group” on page 411
set server group Configures a group of one to four RADIUS servers.
Syntax — set server group group-name members server-name1
[server-name2] [server-name3] [server-name4]
■ group-name — Server group name of up to 32 characters, with no
spaces or tabs.
■ members server-name1, server-name2, server-name3,
server-name4
— The names of one or more configured RADIUS
servers. You can enter up to four server names.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — You must assign all group members simultaneously, as shown
in the example. To enable load balancing, use set server group
load-balance enable.
To Next Page
Loading...
