3Com 3CRWX120695A - Clear Dot1 X Max-Req; Clear Dot1 X Port-Control

clear dot1x max-req 417
See Also
■ “display dot1x” on page 421
■ “set dot1x bonded-period” on page 426
clear dot1x max-req Resets to the default setting the number of Extensible Authentication
Protocol (EAP) requests that the WX switch retransmits to a supplicant
(client).
Syntax —
clear dot1x max-req
Defaults — The default number is 20.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — To reset the number of 802.1X requests the WX can send
to the default setting, type the following command:
WX4400# clear dot1x max-req
success: change accepted.
See Also
■ “display dot1x” on page 421
■ “set dot1x max-req” on page 427
clear dot1x
port-control
Resets all wired authentication ports on the WX switch to default 802.1X
authentication.
Syntax —
clear dot1x port-control
By default, all wired authentication ports are set to auto and they process
authentication requests as determined by the set authentication dot1X
command.
Access — Enabled.
History — Introduced in MSS Version 3.0.