3Com 3CRWX120695A - Set Dot1 X Quiet-Period; Set Dot1 X Reauth

set dot1x quiet-period 429
set dot1x
quiet-period
Sets the number of seconds an WX remains quiet and does not respond
to a supplicant after a failed authentication.
Syntax —
set dot1x quiet-period seconds
■ seconds — Specify a value between 0 and 65,535.
Defaults — The default is 60 seconds.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — Type the following command to set the quiet period to
90 seconds:
WX4400# set dot1x quiet-period 90
success: dot1x quiet period set to 90.
See Also
■ “clear dot1x quiet-period” on page 418
■ “set dot1x wep-rekey-period” on page 433
set dot1x reauth Determines whether the WX switch allows the reauthentication of
supplicants (clients).
Syntax —
set dot1x reauth {enable | disable}
■ enable — Permits reauthentication.
■ disable — Denies reauthentication.
Defaults — Reauthentication is enabled by default.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — Type the following command to enable reauthentication of
supplicants (clients):
WX4400# set dot1x reauth enable
success: dot1x reauthentication enabled.