458 CHAPTER 17: RF DETECTION COMMANDS
Examples — The following command displays the devices detected by
3Com radio 00:0b:0e:00:0a:6a:
WX1200# display rfdetect visible 00:0b:0e:00:0a:6a
Total number of entries: 4
Transmit MAC Chan RSS
----------------- -------- -------
00:0b:0e:00:02:01 56 -74
00:0b:0e:00:03:41 36 -44
00:0b:0e:00:0b:01 52 -79
00:0b:0e:ff:00:01 36 -84
The following command displays the devices detected by 3Com radio 1
on the MAP connected to WX port 3:
WX1200# display rfdetect visible ap 3 radio 1
Total number of entries: 3
Transmit MAC Chan RSS
----------------- -------- -------
00:06:25:51:e9:ff 10 -77
00:0b:0e:00:03:80 1 -79
00:0b:0e:00:a6:00 1 -71
Table 88 describes the fields in this display.
See Also
■ “display rfdetect data” on page 453
■ “display rfdetect mobility-domain” on page 455
set rfdetect
active-scan
Disables or reenables active RF detection scanning on a WX switch. When
active scanning is enabled, the MAP radios managed by the switch look
Table 88 display rfdetect visible Output
Field Description
Transmit MAC BSSID of the device.
BSSIDs that begin with 00:0b:0e belong to other 3Com
radios.
Chan Number of the channel on which the MAP radio detected
the BSSID.
RSS Received signal strength indication (RSSI) — the strength of
the RF signal detected by the MAP radio, in decibels referred
to 1 milliwatt (dBm).
To Next Page
Loading...
