486 CHAPTER 19: TRACE COMMANDS
See Also
■ “clear trace” on page 482
■ “display trace” on page 483
set trace dot1x Traces 802.1X sessions.
Syntax — set trace dot1x [mac-addr mac-address] [port port-num]
[
user username] [level level]
■ mac-addr mac-address — Traces a MAC address. Specify a MAC
address, using colons to separate the octets (for example,
00:11:22:aa:bb:cc).
■ port port-num — Traces on a WX port number.
■ user username — Traces a user. Specify a username of up to
80 alphanumeric characters with no spaces.
■ level level — Determines the quantity of information included in
the output. You can set the level with an integer from 1 to 10, where
level 10 provides the most information. Levels 1 through 5 provide
user-readable information. If you do not specify a level, level 5 is the
default.
Defaults — The default trace level is 5.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command starts a trace for the 802.1X
sessions for MAC address 00:01:02:03:04:05:
WX4400# set trace dot1x mac-addr 00:01:02:03:04:05:
success: change accepted.
See Also
■ “clear trace” on page 482
■ “display trace” on page 483
set trace sm Traces session manager activity.
To Next Page
Loading...
