500 CHAPTER 21: BOOT PROMPT COMMANDS
autoboot Displays or changes the state of the autoboot option. The autoboot
option controls whether a WX switch automatically boots a system image
after initializing the hardware, following a system reset or power cycle.
Syntax —
autoboot [ON | on | OFF | off]
■ ON — Enables the autoboot option.
■ on — Same effect as ON.
■ OFF — Disables the autoboot option.
■ off — Same effect as OFF.
Defaults — The autoboot option is enabled by default.
Access — Boot prompt.
History — Introduced in MSS Version 3.0.
Examples — The following command displays the current setting of the
autoboot option:
boot> autoboot
The autoboot flag is on.
See Also
■ “boot” on page 501
Boot Profile
Management, cont.
“next” on page 511
“change” on page 503
“delete” on page 505
Diagnostics “diag” on page 505
“test” on page 513
Table 95 Boot Prompt Commands by Usage (continued)
Type Command
To Next Page
Loading...
