512 CHAPTER 21: BOOT PROMPT COMMANDS
Examples — To activate the boot profile in the next slot and display the
profile, type the following command:
boot> next
BOOT Index: 0
BOOT TYPE: c
DEVICE: boot1:
FILENAME: testcfg
FLAGS: 00000000
OPTIONS: run=nos;boot=0
See Also
■ “change” on page 503
■ “create” on page 504
■ “delete” on page 505
■ “display” on page 507
reset Resets a WX switch’s hardware.
Syntax — reset
Defaults — None.
Access — Boot prompt.
History — Introduced in MSS Version 3.0.
Usage — After resetting the hardware, the reset command attempts to
load a system image file only if other boot settings are configured to do
so.
Examples — To immediately reset the system, type the following
command at the boot prompt:
boot> reset
WX Bootstrap 3.1 Release
Testing Low Memory 1 ............
Testing Low Memory 2 ............
CISTPL_VERS_1: 4.1 <SanDisk> <SDP> <5/3 0.6>
Reset Cause (0x0100) is WARM
To Next Page
Loading...
