54 CHAPTER 3: SYSTEM SERVICE COMMANDS
Default — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command sets the IP address of the WX
switch to 192.168.253.1:
WX4400# set system ip-address 192.168.253.1
success: change accepted.
See Also
■ “clear system” on page 39
■ “set interface” on page 135
■ “display system” on page 42
set system location Stores location information for the WX switch.
Syntax — set system location string
■ string — Alphanumeric string up to 256 characters long, with no
blank spaces.
Default — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — You cannot include spaces in the system location string.
To view the system location string, type the display system command.
Examples — To store the location of the WX switch in the WX’s
configuration, type the following command:
WX4400# set system location first-floor-bldg3
success: change accepted.
See Also
■ “clear system” on page 39
■ “display system” on page 42
To Next Page
Loading...
