60 CHAPTER 4: PORT COMMANDS
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command clears the names of ports 1
through 3:
WX4400# clear port 1-3 name
See Also
■ “display port status” on page 66
■ “set port name” on page 78
clear port
preference
Resets a gigabit Ethernet port on a WX4400 to use the GBIC (fiber)
interface for the active link.
Syntax —
clear port preference port-list
■ port-list — List of physical ports. MSS clears the preference on all
the specified ports.
Defaults — When both the copper and fiber interfaces of a gigabit
Ethernet port are connected, the GBIC (fiber) interface is the active link.
The RJ-45 (copper) link is unused.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — This command applies only to the WX4400. This command
does not affect a link that is already active on the port.
Examples — The following command clears the preference set on port 2
on a WX4400 switch:
WX4400# clear port preference 2
See Also
■ “display port preference” on page 65
■ “set port preference” on page 80
To Next Page
Loading...
