62 CHAPTER 4: PORT COMMANDS
Examples — The following command clears port 5:
WX1200# clear port type 5
This may disrupt currently authenticated users.
Are you sure? (y/n) [n]y
success: change accepted.
See Also
■ “set port type ap” on page 82
■ “set port type wired-auth” on page 86
display port
counters
Displays port statistics.
Syntax —
display port counters
[octets | packets | receive-errors | transmit-errors |
collisions | receive-etherstats |
transmit-etherstats] [port port-list]
■ octets — Shows octet statistics.
■ packets — Shows packet statistics.
■ receive-errors— Shows errors in received packets.
■ transmit-errors — Shows errors in transmitted packets.
■ collisions — Shows collision statistics.
■ receive-etherstats — Shows Ethernet statistics for received
packets.
■ transmit-etherstats — Shows Ethernet statistics for transmitted
packets.
■ port port-list — List of physical ports. If you do not specify a port
list, MSS shows statistics for all ports.
Defaults — None.
Access — All.
History — Introduced in MSS Version 3.0.
Usage — You can specify one statistic type with the command.
To Next Page
Loading...
