3Com 3CRWX120695A - Page 83

set port type ap 83
country-specific regulations on the WX switch. See “set system
countrycode” on page 51.
For an MAP that is indirectly connected to the WX switch through an
intermediate Layer 2 or Layer 3 network, use the
set dap command to
configure a Distributed MAP.
Before changing the port type from ap to wired-auth or from
wired-auth to ap, you must reset the port with the clear port type
command.
Syntax —
set port type ap port-list model {ap2750 | mp-52 |
mp-101 | mp-122 | mp-241 | mp-252 | mp-262 | mp-341 | mp-352}
poe {enable | disable} [radiotype {11a | 11b | 11g}]
■ port-list — List of physical ports.
■ model {ap2750 | mp-52 | mp-101 | mp-122 | mp-241 | mp-252 |
mp-262 | mp-341 | mp-352}
— MAP access point model:
■ ap2750 — Contains one radio that can be configured through
software for 802.11a or 802.11b/g.
■ mp-52 — Contains one 802.11a radio and one 802.11b radio, with
adjustable external antennas.
■ mp-101 — Contains one radio that can be configured through
software for 802.11a or 802.11b.
■ mp-122 — Contains one 802.11a radio and one 802.11b/g radio.
■ mp-241 — Contains one radio that can be configured through
software for 802.11a or 802.11b/g.
■ mp-252 — Contains one 802.11a radio and one 802.11b radio.
■ mp-262 — Contains one 802.11a radio and one 802.11b radio,
and a connector for an external antenna for the 802.11b/g radio.
■ mp-341 — Contains one radio that can be configured through
software for 802.11a or 802.11b/g, and a connector for an
external antenna for the 802.11b/g radio.
■ mp-352 — Contains one 802.11a radio and one 802.11b radio,
and a connector for an external antenna for the 802.11b/g radio.
■ poe enable | disable — Power over Ethernet (PoE) state.