34 CHAPTER 2: INSTALLING AND CONNECTING A WX SWITCH
For 1000BASE-SX or 1000BASE-LX fiber, make sure you insert the two
cable ends in the proper sides (transmit or receive). Otherwise, the link
does not work.
4 Observe the upper LED to the right of the GBIC port:
■ If the LED is green, the 1000-Mbps link is operational.
■ If the LED is blinking amber, traffic is active on the 1000-Mbps link.
■ If the LED is unlit, the link is not operational. Check the cable and
verify that the device at the other end of the link is operational.
To remo ve a GB IC:
1 Remove the network cable(s).
2 Insert the protective covering(s) into the port connector(s).
3 Squeeze the clips on the sides of the GBIC and pull the GBIC out of the
slot.
To Next Page
Loading...
