Configuring User Authentication 79
Figure 10 Pass-Through User Authentication
Configuring RADIUS Servers for Pass-Through Authentication
To configure MSS to use a RADIUS server, use the following command:
set radius server {server-name} [address ip-addr]
[auth-port port-number] [acct-port port-number]
[timeout seconds] [retransmit number] [deadtime minutes]
[key string] [author-password password]
To add the server(s) to a server group, use the following command:
set server group group-name members server-name1
[server-name2] [server-name3] [server-name4]
To configure MSS to load-balance authentication requests among the
servers, use the following command:
set server group group-name load-balance enable | disable
To verify the change, use the following command:
WX
s
wi
t
c
h
Router
User A
RADIUS
server
User
A
TLS
M
A
P
M
A
P
To Next Page
Loading...
