Importing or Drawing Floor Details 127
tools in the Insert RF Obstacle group box. (See“Drawing RF Obstacles” on
page 132.)
To draw an object
1 In the Free Draw group box of the Edit Content page, click one of the
following icons and draw the object as described:
2 Click Finish to save the changes and close the wizard.
Changing an
Individual Floor’s
Properties
To change an individual floor’s properties, you use the Setup page of the
Building wizard. Follow these steps.
1 In the Setup page of the Building wizard, select the floor by clicking in the
Level column or Floor Plan column.
2 Click the Edit floor properties icon. The Floor Properties dialog box
appears.
Object Action
(circle)
Diagonally drag the cursor over the area where you want
the circle to appear.
(square)
Diagonally drag the cursor over the area where you want
the square to appear.
(parallelogram)
1 Click at a vertex, and drag the cursor to the next vertex.
2 Click again, and drag the cursor until the parallelogram
takes the shape you want.
3 Click to finish.
(polygon)
1 Click at a vertex, then move the cursor to the next
vertex.
2 Repeat until the polygon takes the shape you want.
For a polygon with n sides, click n-1 additional times at
the vertices. For example, to draw a 7-sided polygon,
click at 6 vertices.
3 At the last vertex before completing the shape,
Right-click to complete the polygon.
(line)
1 Click at the start of the line.
2 Drag the cursor to the end of the line.
3 Click to finish.
To Next Page
Loading...
