204 CHAPTER 5: CONFIGURING WX SYSTEM AND ADMINISTRATIVE PARAMETERS
You can only add network ports as static multicast router ports or
multicast receiver ports. Ports you add are immediately added to the list
and do not age out.
You cannot add MAP ports or wired authentication ports as static
multicast ports. However, MSS can dynamically add these port types to
the list of multicast ports based on multicast traffic.
To add or remove static multicast router and receiver ports:
1 In the Create VLAN wizard, click Member IGMP Setup. The Member
IGMP Setup page appears.
2 To add a static multicast receiver port, select the Forward Multicast IP
Out checkbox for each port you want to add.
By default, ports are not selected. To remove a static multicast receiver
port, clear the checkbox.
To Next Page
Loading...
