6
CONFIGURING WIRELESS
PARAMETERS
This chapter describes how to configure the following wireless
parameters: SSIDs, service profiles, radio profiles, directly connected and
distributed MAP access points, and active RF scanning.
Overview This chapter describes how to configure the following wireless
parameters for WX switches:
■ Service Set Identifiers (SSIDs)
■ Service profiles, which enable or disable beaconing for an SSID and
define the encryption used for that SSID’s wireless traffic
■ Radio profiles, which assign IEEE 802.11 settings and a service profile
to radios
■ MAP access points
■ Active scanning for rogue devices
To set these parameters, you can use the Wireless page of the WX Switch
wizard. Figure 11 shows an example of this wizard page.
To Next Page
Loading...
