322 CHAPTER 7: CONFIGURING AUTHENTICATION, AUTHORIZATION, AND ACCOUNTING PARAMETERS
To add a server group, click Create and go to “To define a RADIUS server
group” on page 298. After you create the server group, click Choose
Available and then select the server group from the list.
4 Do one of the following:
■ To configure accounting, go to “To set the accounting method for
administrator access”.
■ To save changes and close the wizard, click Finish.
To set the accounting method for administrator access
1 Click Accounting at the top of the wizard to display the following page.
2 To enable this accounting rule, select Enabled. By default, a rule you
configure in 3WXM is disabled, which means 3WXM does not add the
rule to a WX switch’s configuration.
3 Select one of the following record options:
■ Select Start-Stop to specify that records are sent at the start of a
session and the end of a session.
■ Select Stop-Only to specify that records are sent only at the end of a
session.
4 To select the accounting method, click Choose Available, then select the
method from the list:
To Next Page
Loading...
