3Com 3CRWX120695A - To Display the List; To Remove a Third-Party AP

Converting a Rogue into a Third Party AP 481
3 Enter the information for the AP and place the icon for the AP in its floor
location, if applicable. (See “Adding a Third-Party Access Point” on
page 148.)
To display the list In the Organizer panel, click on Third Party APs. The third-party APs are
listed.
To remov e a
third-party AP
To remove a third-party AP, use the following procedure.
1 In the Organizer panel, click on Third Party APs. The third-party APs are
listed.
2 Right-click on the third-party AP you want to remove and select Delete.
The address is removed from the third-party AP list. If the device is
detected by rogue detection, the device appears in the rogue list. Set the
display filter of the Rogue Detection tab to Current and click the Refresh
option on the tab’s toolbar.