528 APPENDIX C: 3WXM VERIFICATION RULES
Table 84 RADIUS Server Group Rules
Title Description Classification
RADIUS server group
RADIUS server check
Verifies that at least one RADIUS server is
defined in a RADIUS server group.
Error
RADIUS server group
RADIUS servers check
Verifies that a RADIUS server group has no
more than four servers in the list.
Error
Table 85 Radio Profile Rules
Title Description Classification
Associated service
profiles check
Verifies that the same SSID is not assigned
to more than one service profile.
Error
Table 86 SNMP Rules
Title Description Classification
SNMP trap enable
check
Verifies that SNMP traps are enabled on
the monitoring service for a WX switch
monitored by the service, when monitoring
options that use trap data are enabled.
Error
SNMP trap receiver
check
Verifies that the option to add the
monitoring service’s IP address to a
monitored WX switch’s list of trap receivers
is enabled.
Error
Table 87 Service Profile Rules
Title Description Classification
Best practices
(security): Open service
profile check
Checks whether a service profile’s SSID is
encrypted or clear, and recommends
encrypting the SSID’s traffic.
Warning
Best practices
(security): service
profile static WEP
check
Checks whether an SSID’s encryption type
is static WEP and, if it is, advises using a
stronger encryption type.
Warning
Empty SSID check Verifies that encrypted and unencrypted
data SSIDs are not empty.
Error
Pre-shared key check Verifies that the pre-shared key value is 64
hexadecimal characters long if pre-shared
key authentication is selected for WPA
mode.
Error
WEP key-length check Verifies that the WEP key length is 0, 10, or
26 digits long.
Error
To Next Page
Loading...
