1-1
1 MSTP Configuration
Go to these sections for information you are interested in:
z MSTP Overview
z Configuring Root Bridge
z Configuring Leaf Nodes
z Performing mCheck Operation
z Configuring Guard Functions
z Configuring Digest Snooping
z Configuring Rapid Transition
z STP Maintenance Configuration
z Enabling Trap Messages Conforming to 802.1d Standard
z Displaying and Maintaining MSTP
z MSTP Configuration Example
STP Overview
Functions of STP
Spanning tree protocol (STP) is a protocol conforming to IEEE 802.1d. It aims to eliminate loops on data
link layer in a local area network (LAN). Devices running this protocol detect loops in the network by
exchanging packets with one another and eliminate the loops detected by blocking specific ports until
the network is pruned into one with tree topology. As a network with tree topology is loop-free, it
prevents packets in it from being duplicated and forwarded endlessly and prevents device performance
degradation.
Currently, in addition to the protocol conforming to IEEE 802.1d, STP also refers to the protocols based
on IEEE 802.1d, such as RSTP, and MSTP.
Protocol packets of STP
STP uses bridge protocol data units (BPDUs), also known as configuration messages, as its protocol
packets.
STP identifies the network topology by transmitting BPDUs between STP compliant network devices.
BPDUs contain sufficient information for the network devices to complete the spanning tree calculation.
In STP, BPDUs come in two types:
z Configuration BPDUs, used to calculate spanning trees and maintain the spanning tree topology.
z Topology change notification (TCN) BPDUs, used to notify concerned devices of network topology
changes, if any.
Basic concepts in STP
1) Root bridge
A tree network must have a root; hence the concept of root bridge has been introduced in STP.
To Next Page
Loading...
