2-13
Operation Command Description
Configure a shared FTP server
for the cluster
ftp-server ip-address
Optional
By default, the management
device acts as the shared FTP
server.
Configure a shared TFTP
server for the cluster
tftp-server ip-address
Optional
By default, no shared TFTP
server is configured.
Configure a shared logging
host for the cluster
logging-host ip-address
Optional
By default, no shared logging
host is configured.
Configure a shared SNMP host
for the cluster
snmp-host ip-address
Optional
By default, no shared SNMP
host is configured.
Enabling management VLAN synchronization
By default, VLAN 1 is the management VLAN. To specify another VLAN as the management VLAN for
the cluster, you must configure the same management VLAN on all the devices that are about to join the
cluster.
By enabling the management VLAN synchronization function on the management device, you can
enable the management device to send a management VLAN synchronization packet periodically to
the connected devices. After the devices receive the management VLAN synchronization packet, they
set their own management VLANs according to the packet. In this way, all devices set the same
management VLAN automatically, and thus simplify your configurations.
Follow these steps to enable management VLAN synchronization:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter cluster view
cluster
Required
Enable management VLAN
synchronization
management-vlan
synchronization enable
Required
Disabled by default.
Configuring Member Devices
Member device configuration tasks
Table 2-12 Member device configuration tasks
Operation Description
Enabling NDP globally and on specific ports Required
Enabling NTDP globally and on a specific port Required
Enabling the cluster function Required
Accessing the shared FTP/TFTP server from a
member device
Optional
To Next Page
Loading...
