1-28
[Sysname-remote-ping-administrator-tcpprivate] display remote-ping history administrator
tcpprivate
remote-ping entry(admin administrator, tag tcpprivate) history record:
Index Response Status LastRC Time
1 4 1 0 2000-04-02 08:26:02.9
2 5 1 0 2000-04-02 08:26:02.8
3 4 1 0 2000-04-02 08:26:02.8
4 5 1 0 2000-04-02 08:26:02.7
5 4 1 0 2000-04-02 08:26:02.7
6 5 1 0 2000-04-02 08:26:02.6
7 6 1 0 2000-04-02 08:26:02.6
8 7 1 0 2000-04-02 08:26:02.5
9 5 1 0 2000-04-02 08:26:02.5
10 7 1 0 2000-04-02 08:26:02.4
For detailed output description, see the corresponding command manual.
UDP Test (Udpprivate Test) on the Specified Ports
Network requirements
Both the remote-ping client and the remote-ping server are 4200G Ethernet switches. Perform a
remote-ping Udpprivate test on the specified ports between the two switches to test the RTT of UDP
packets between this end (remote-ping client) and the specified destination end (remote-ping server).
Network diagram
Figure 1-9 Network diagram for the Udpprivate test
Configuration procedure
z Configure remote-ping Server (Switch B):
# Enable the remote-ping server and configure the IP address and port to listen on.
<Sysname> system-view
[Sysname] remote-ping-server enable
[Sysname] remote-ping-server udpecho 10.2.2.2 8000
z Configure remote-ping Client (Switch A):
# Enable the remote-ping client.
<Sysname> system-view
[Sysname] remote-ping-agent enable
# Create a remote-ping test group, setting the administrator name to administrator and test tag to
udpprivate.
[Sysname] remote-ping administrator udpprivate
# Configure the test type as udpprivate.
To Next Page
Loading...
