3Com 4200G PWR - Package Contents; Choosing a Suitable Site

22 3Com Switch 4200G Family
Command Reference
ip address dhcp-alloc
Use the ip address dhcp-alloc command to configure VLAN interface to obtain an IP address using
DHCP.
VLAN Interface view
ip host
Use the ip host command to configure a host name and the corresponding IP address for a switch.
System view
ip http acl
Use the ip http acl command to apply an ACL to filter Web users.
System view
User Interface view
ip-pool
Use the ip-pool command to configure a private IP address range for cluster members on the switch to
be set as the management device.
Cluster view
ip route-static
Use the ip route-static command to configure a static route.
Use the
ip route-static command to configure a static route, whose validity depends on detecting results
as follows: valid when the detecting result is reachable or invalid when the detecting result is unreachable.
System view
ip route-static
Use the ip route-static command to configure a static route, whose validity depends on detecting results
as follows: valid when the detecting result is reachable or invalid when the detecting result is unreachable.
System view
key
Use the key command to specify a shared key for the RADIUS authentication/authorization packets or
accounting packets.
RADIUS Scheme view
lacp enable
Use the lacp enable command to enable the LACP protocol on the current port.
Ethernet Port view
lacp port-priority
Use the lacp port priority command to configure port priority value.
Ethernet Port view
lacp system-priority
Use the lacp system-priority command to configure system priority value.
System view
language-mode
Use the language-mode command to toggle between the language modes (that is, language environments)
of the command line interface (CLI) to meet your requirement.
User view
lcd
Use the lcd command to display the local work directory on the FTP client.
FTP Client view
level
Use the level command to set the priority level of the user.
Local User view
link-aggregation group description
Use the link-aggregation group description command to set a description for an aggregation group.
System view
link-aggregation group mode
Use the link-aggregation group mode command to create a manual or static aggregation group.
System view
local-server
Use the local-server command to configure the parameters of local RADIUS server.
System view
local-user
Use the local-user command to add a local user and enter local user view.
System view