3Com 4200G PWR - Page 30

30 3Com Switch 4200G Family
Command Reference
quit
Use the quit command to terminate the connection to the remote SSH server.
User view
quit
Use the quit command to terminate the connection to the remote SFTP server and exit to system view.
SFTP Client view
quit
Use the quit command to terminate FTP control connection and FTP data connection and quit to user view.
This command has the same effect as that of the bye command.
FTP Client view
quit
Use the quit command to return from current view to lower level view, or exit the system if current view is
user view.
Any view
radius nas-ip
Use the radius nas-ip command to set the source IP address used by the switch to send RADIUS packets.
System view
radius-scheme
Use the radius-scheme command to specify the RADIUS scheme to be used by the current ISP domain.
ISP Domain view
radius scheme
Use the radius scheme command to create a RADIUS scheme and enter its view.
System view
radius trap
Use the radius trap command to enable the switch to send trap messages when its RADIUS
authentication or accounting server turns down.
System view
reboot
Use the reboot command to restart an Ethernet switch.
User view
reboot member
Use the reboot member command to reboot a specified member device on the management device.
Cluster view
region-name
Use the region-name command to set an MST region name to a switch.
MST Region view
remote-probe vlan
Use the remote-probe vlan enable command to enable the remote-probe port mirror port feature on the
VLAN of the switch.
VLAN view
remotehelp
Use the remotehelp command to display help information about the FTP protocol command.
FTP Client view
remove
Use the remove command to delete the specified file from the server.
SFTP Client view
rename
Use the rename command to change the name of the specified file on the SFTP server.
SFTP Client view
rename
Use the rename command to rename a file or a directory. If the target file name or directory name is the
same with any existing file name or directory name, you will fail to rename a file.
User view
rename
Use the rename command to rename a file on a remote host.
FTP Client view
reset arp
Use the reset arp command to remove information that is no longer required from the ARP mapping table.
User view