3Com 4200G PWR - Page 33

3Com Switch 4200G Family 33
Command Reference
rule (Basic ACL)
Use the rule command to define an ACL rule.
Basic ACL view
rule comment
Use the rule comment command to define the comment string for an ACL rule.
Advanced ACL view / Layer 2 ACL view
rule (Layer 2 ACL)
Use the rule command to define an ACL rule.
Layer 2 ACL view
save
Use the save command to save the current configuration to a configuration file in the flash memory.
Any view
schedule reboot at
Use the schedule reboot at command to schedule a reboot on the current switch and set the reboot date
and time.
User view
schedule reboot delay
Use the schedule reboot delay command to schedule a reboot on the switch, and set the reboot waiting
delay.
User view
scheme
Use the scheme command to configure the AAA scheme to used by the current ISP domain.
ISP Domain view
screen-length
Use the screen-length command to set the number of lines the terminal screen can contain.
User Interface view
secondary accounting
Use the secondary accounting command to set the IP address and port number of the secondary RADIUS
accounting server.
RADIUS Scheme view
secondary authentication
Use the secondary authentication command to set the IP address and port number of the secondary
RADIUS authentication/authorization server.
RADIUS Scheme view
security-policy-server
Use the security-policy-server command to set the IP address of a security policy server.
RADIUS Scheme view
self-service-url
Use the self-service-url command to either enable or disable the self-service server location function.
ISP Domain view
send
Use the send command to send messages to a specified user interface or all user interfaces.
User view
server-type
Use the server-type command to configure the RADIUS server type supported by the Switch.
RADIUS Scheme view
service-type
Use the command service-type to authorize a user access to the specified services.
Local User view
service-type
Use the service-type command to specify the login type and the corresponding available command level.
Local User view
service-type multicast
Use the service-type multicast command to set the current VLAN as a multicast VLAN.
VLAN view
set authentication password
Use the set authentication password command to set the local password.
User Interface view