3Com 4200G PWR - Setting Up Overview

34 3Com Switch 4200G Family
Command Reference
sftp
Use the sftp command to establish a connection to the SFTP server and enter SFTP client view.
System view
sftp server enable
Use the sftp server enable command to enable the secure FTP (SFTP) server.
System view
sftp time-out
Use the sftp time-out command to set the timeout time for the SFTP user connection.
System view
shell
Use the shell command to make terminal services available for the user interface.
User Interface view
shutdown
Use the shutdown command to disable an Ethernet port.
Ethernet Port view
shutdown
Use the shutdown command to disable the VLAN interface.
VLAN Interface view
smarton
Use the smarton command to enable the SmartOn function for an Ethernet port with supplicant systems
attached.
Ethernet Port view
smarton password
Use the smarton password command to set the password to be used by the SmartOn function.
System view
smarton switchid
Use the smarton switchid command to set the switch ID.
System view
smarton timer
Use the smarton timer command to set the supplicant timeout timer for SmartOn-enabled supplicant
systems.
System view
snmp-agent
Use the snmp-agent command to enable SNMP Agent.
System view
snmp-agent community
Use the snmp-agent community command to set a community name and to enable users to access the
switch through SNMP. You can also optionally use this command to apply an ACL to filter network
management users.
System view
snmp-agent community
Use the snmp-agent community command to set the community access name and enable access to SNMP.
System view
snmp-agent group
Use the snmp-agent group command to configure a SNMP group. You can also optionally use this
command to apply an ACL to filter network management users.
System view
snmp-agent group
Use the snmp-agent group command to configure a new SNMP group, that is, to map SNMP user to SNMP
view.
snmp-agent local-engineid
Use the snmp-agent local-engineid command to set the engine ID of the local SNMP entity.
System view
snmp-agent log
Use the snmp-agent log command to enable the logging function for network management.
System view