3Com 4210G Series - Use Front Mounting Brackets and a Tray to Install a Switch

3-4
Figure 3-4 Fix front mounting brackets (1)
(1) Front panel of the switch
Step4 Place the switch horizontally in a proper position, and fix the other end of mounting brackets to the front
brackets with screws and captive nuts, as shown in
Figure 3-5.
Figure 3-5 Fix front mounting brackets (2)
(3)
(1) (1)
(2)
(1) Front square-holed post (2) Front panel
(3) Front mounting bracket
Use Front Mounting Brackets and a Tray to Install a Switch
All models of the Switch 4210G support installation using front mounting brackets together with a tray.
Follow these steps to install a switch into a 19-inch standard cabinet:
Step1 Wear an ESD-preventive wrist strap and ensure a good skin contact and grounding.
Step2 Check the grounding and stability of the cabinet.
Step3 Fix the delivered tray horizontally in a proper position.
Step4 Take out the screws which are packed together with the front mounting brackets, and fix one end of
mounting brackets to the switch, as shown in
Figure 3-4.