3Com 4210G Series - Changing the Startup Mode

To Next Page

To Previous Page

4-7

Item Description

4. Delete file from flash Delete files from the flash memory

5. Modify bootrom password Modify the Boot ROM password

6. Enter bootrom upgrade menu Enter the Boot ROM update menu

7. Skip current configuration file

Skip the current configuration file (this configuration is

valid once)

8. Set bootrom password recovery Restore the Boot ROM password

9. Set switch startup mode Set the startup mode of the switch

0. Reboot Restart the switch

z If you perform no operation or press a key other than Ctrl + B within one second, Once the

remaining waiting time becomes zero, the system begins to automatically start up and the following

information is displayed:

Auto-booting...

Decompress Image................................................................

................................................................................

...........................................OK!

User interface aux0 is available.

Press ENTER to get started.

The appearance of "Press ENTER to get started" indicates that the automatic startup of the switch is

complete.

Press Enter. The following prompt is displayed:

You can configure the switch now.

Changing the Startup Mode

By default, the system starts up in fast mode. If you want to change the startup mode to normal, press

Ctrl + B within one second to enter the Boot Menu showed below:

Other manuals for 3Com 4210G Series